A Tactical Polymer Holster which fits all duty belts in use in Australia - in fact any belt up to 68mm - there is even an optional molle mount. Fits Sn1per Mini, Sn1per II series, Pro Police and all of our torches which are single battery and use a 25mm body.
February, 2026 new stock has arrived built in the new factory in Thailand now, not China. There have been some really nice improvements on the new model. The adjustment to ride height is much easier to both see and use (some users never realised it had ride height adjustment). The ride height is adjusted by pushing in a button on each side of the ride height adjustment bar, which then locks in to a toothed section, now with nine options.There is an included allen key which allows you to rotate the torch through a full 360 degrees (yes, even upside down) to get it ride comfortably for your body type. There is also a 25mm tab which presses in to your belt so the holster maintains the position you set it in.
We finally have a great replacement for the Bladetch torch holsters, this new flashlight holster is an evolution of our previous polymer flashlight holster. This hard polymer holster retains all our 35mm head torches, Sn1per Mini, Sn1per II, etc, in a head down (or head up, your choice) position, then retains the torch by the body. There is a screw adjustment so you adjust the retention to suit your individual retention requirements. If you use one of our torches with a 42mm head like the Pro Police, the torch is retained in the head up position and then retained by the body in the same manner. This polymer torch holster has great retention which has been field tested. It still offers fast and easy deployment even with the high retention.
The belt loop is openable so you don't have to remove your duty or appointment belt to install the holster. The loop can fit up to 68mm belts and has a ride height adjustment lug with nine positions instead of the previous four, so you can adjust the ride height to suit your personal requirements.
The holster and belt loop are attached by an allen bolt with captive nut and we provide an allen key so you can adjust the torch holster through a full 360 degrees, so you can mount your torch horizontally or even upside down if you prefer! This same allen bolt mounting allows you to change from a belt loop to the optional molle mount if you wish. Again when on the molle mount you can choose through 360 degrees the angle you would like your torch to ride at.